How to install fcc-id frequency setting software

The engineer's prototype is generally connected with these wires: the MoSi control line GND ground wire miso control line CSB control line CLK control line.

Fixed frequency software: you can find chip suppliers. They all have

1. Declaration of conformity

The product responsible party (manufacturer or importer) will test the product at the qualified testing agency designated by FCC, and make a test report. If the product meets the FCC standard, the product shall be labeled accordingly, and the user manual shall state that the product complies with the FCC standard, and the test report shall be kept for FCC to ask for.

2. apply for ID

First apply for a FRN to fill in other forms. If the applicant is applying for the FCC ID for the first time, it needs to apply for a permanent grant code. While waiting for FCC approval to distribute grant code to the applicant, the applicant shall seize the time to test the equipment. By the time all materials required by FCC are prepared and the test report is completed, FCC shall have approved grant code. The applicant uses this code, test report and required materials to complete FCC form 731 and form 159 on the Internet. After the FCC receives the form 159 and the remittance, it begins to accept the application for certification. The average time for FCC to accept ID application is 60 days. At the end of acceptance, the FCC will send the original grant of FCC ID to the applicant. After obtaining the certificate, the applicant can sell or export the corresponding products.

prototype

1. At least one qualified prototype shall be provided for each model applied for certification. (two or more are recommended)

2. The prototype provided must be formal and qualified, and its internal electrical structure and appearance must be consistent with the batch prototype exported later

3. The trademark model on the prototype must be clear and reliable

Application materials

Full name and contact address of the manufacturer and the applicant of the product to be certified.

A copy of the installation and use manual of the certified product to be provided to the user. (if the product does not have a user manual, a draft copy of the relevant content can be provided)

Product electrical schematic diagram and working principle description. (if the product has grounding or antenna, it shall be described)

The working oscillation frequency table of relevant products shall list the signal propagation path and corresponding oscillation frequency.

Other product features that need to be explained.

Note:

1. Relevant documents shall be in Chinese and English.

2. In order to shorten the certification cycle, the information provided should be in the form of electronic documents.

3. In the process of certification, for some special cases, it may be necessary for the enterprise to supplement other relevant information